Summers Disk-Chisel Uživatelský manuál stáhnout pdf (Strana 46)

2-34

SECTION 2 – HYDRAULIC SET-UP (32’-40’)

7. Charge Wing Lift Cylinders.

– Block rod end of cylinders so cylinders can extend without hitting anything.

– Fully cycle the cylinders several times to make sure that all air has been removed from sys-

tem.

– Leave cylinders in fully extended position.

8. Connect rod end of cylinders to wing. Follow these steps and see drawing below.

– Use pivot bolt, washers with collars, 1-1/4” washers, 1” washer and 1” lock nut provided.

– 1-1/4” washers must slide freely inside wing ﬂ amecuts.

– Do not over tighten lock nut. Pivot bolt must rotate freely.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 118 119

Žádné komentáře

Summers Disk-Chisel Uživatelský manuál Strana 46